杭州湾中部实测波浪特性分析   总被引：1，自引：0，他引：1  

杨斌  杨忠良  叶钦  张俊彪  施伟勇 《海洋工程》2018,36(3):96-103

利用杭州湾中部一年实测波浪资料,分析该地区的波参数统计变化特性,采用最小二乘法拟合得出相关参数之间的关系式,并统计分析了频谱特性。结果表明:杭州湾中部以小浪和轻浪为主,在各月分布较为均匀,年平均周期为2.97 s;最大一次波浪过程为冷空气影响所致,影响强度大于台风莫拉克;常浪向分布在东北至东南向,其中又以小浪出现较多,对应的波周期以2~4 s为主;强浪向主要分布在西北和东北方向,对应的波周期主要分布在3~5 s;多数特征波参数之间相关关系较好;由谱分析得知风浪占多数,且以单峰为主。研究结果可为相关工程和理论研究提供基础资料。  相似文献   

基于高斯两步移动搜寻法的村镇避难场所可达性研究     

但文羽  肖映辉  胡周灵  詹庆明 《地球信息科学学报》2018,20(10):1412-1421

避难场所可达性是指避难场所与受灾居民之间的通达性,即灾害发生时,避难人员通过避难疏散通道到达避难场所的难易程度,是评价避难场所布局合理性的重要指标。本研究结合高斯两步移动搜寻法和网络分析法,从供需双向出发对村镇地区避难场所进行可达性分析。2种方法的结合,既充分考虑了需求点与设施点的相互作用,又充分考虑了设施点的吸引力随距离的衰减关系,并基于实际道路,以步行疏散时间作为搜索半径,降低了传统研究中因忽略供需间相互作用及实际距离而引起的可达性结果的误差。最后,以神农架松柏镇区为例,验证该方法的实际应用价值。结果表明,该方法能够有效测定村镇地区避难场所的空间可达性,同时,基于GIS软件可以直观地揭示研究区域内避难场所可达性空间分布差异。该方法可为制定科学的村镇防灾减灾规划提供方法支持。  相似文献   

Energy saving performance analysis of contra-rotating azimuth propulsor     

《Applied Ocean Research》2018

The energy saving performance of contra-rotating azimuth propulsor (CRAP) is investigated based on low order potential-based panel method. The hydrodynamic interactions among the forward propeller (FP), rear propeller (RP) and the pod unit (PU) which includes the pod body and the strut are considered through induced velocities which are obtained by panel method. In order to have a better understanding about the energy saving performance of CRAP, the hydrodynamic performance of a conventional propeller (CP) supplying the same thrust with CRAP at design condition is also calculated. At design condition, CRAP has a decrease in delivered power by approximately 8% comparing with CP, and the tangential induced velocities in slipstream show that CRAP recovers the rotational energy of slipstream effectively. At off-design conditions, the rotational speed of CRAP is adjusted to supply the same thrust with CP. In general, the delivered power of CRAP is significantly smaller than that of CP, and the energy saving performance of CRAP increases with the decrease of inflow velocity.  相似文献   

基于经验模态分解和小波分解估算海气通量涡相关计算中的截断时间尺度     

姜浩  赵中阔  樊伟  宋金宝 《海洋与湖沼》2018,49(6):1138-1150

基于时长38天的海表风场实测数据,应用经验模态分解(EmpiricalModeDecomposition,EMD)和小波分解(Wavelet Decomposition, WD)这两种数据处理方法首先对涡相关法中的截断时间尺度(CutoffTimescale,CTS)进行估算,结果显示:基于EMD与WD方法估算出的CTS一般都在40秒左右(EMD的结果略小),远远小于传统涡相关法中CTS的取值(固定为10分钟),且EMD和WD的使用使得每一段数据都能够根据自身的湍流特点而获得合适的CTS; EMD方法和WD方法有效的去除了计算结果中的非湍部分,且对通量传输方向的刻画也更加合理,极大提高了通量的计算精度,所得通量与传统方法计算的通量偏差平均值高达45%;研究还对EMD和WD的优缺点进行了对比分析,结果表明EMD相比于WD有更高的自主性,而WD对信号的分离程度则更高。  相似文献   

利用多源高度计资料提取南海低模态内潮能量     

马静怡  徐永生 《海洋与湖沼》2018,49(6):1169-1177

吕宋海峡由于剧烈变化的地形成为内潮产生的源地,内潮是海洋混合的重要原因。为了认知南海的内潮能通量分布,对南海的内潮有更好的理解,本文利用21世纪以来发射的多颗高度计卫星:J2、J1T、GFO以及EN,提取了吕宋海峡附近内潮的能通量。研究使用了调和分析和高通滤波等方法来提取第一模态内潮,主要提取K_1,K_2,M_2,N_2,O_1,P_1,Q_1和S_2八个分潮。同时结合WOA数据对能通量进行计算。结果表明,目标区域潮汐以全日分潮为主,所选区域的全日分潮中K_1所占比例最大;半日分潮中M_2分潮最强,而内潮的能通量则是M_2分潮所占最大,在吕宋海峡区域M_2能通量为6.45GW。内潮主要产生在地形变化剧烈的地方,海域的大部分地区内潮能量很小。在吕宋海峡中部,全日分潮能通量要小于南部地区,而半日分潮则有较大值。  相似文献   

Seismic electric signals in seismic prone areas          下载免费PDF全文

Nicholas V.Sarlis  Panayiotis A.Varotsos  Efthimios S.Skordas  Seiya Uyeda  Jacques Zlotnicki  Toshiyasu Nagao  Anatoly Rybin  Mary S.Lazaridou-Varotsos  Konstantina A.Papadopoulou 《地震科学（英文版）》2018,31(1):44-51

The Varotsos-Alexopoulos-Nomicos(VAN) method of short-term earthquake prediction was introduced in the 1980s. The VAN method enables estimation of the epicenter, magnitude and occurrence time of an impending earthquake by observing transient changes of the electric field of the Earth termed seismic electric signals(SES). Here, we present a few examples of SES observed in various earthquake prone areas worldwide.  相似文献   

Regional extreme‐dry‐spell frequency analysis using the L‐moments method in the middle reaches of the Yellow River Basin,China          下载免费PDF全文

Dun‐Xian She  Jun Xia  Dan Zhang  Ai‐Zhong Ye  Aditya Sood 《水文研究》2014,28(17):4694-4707

In this research, the regional extreme‐dry‐spell frequency in the middle reaches of the Yellow River Basin (YRB) is studied by the L‐moments method. The research area has been divided into three subregions (regions 1, 2 and 3), which have been identified as homogenous regions. The results of a goodness‐of‐fit test indicate that a generalized normal distribution is the optimal regional model for regions 1 and 2 whereas a generalized Pareto distribution is the optimal regional model for region 3. The return period analysis figures out that the maximum length‐of‐dry‐spell (MxDS) values increase from south to north in the southern part and increase from northeast to southwest in the northern part of the middle reaches of the YRB under different return periods. The increments of quantiles of dry spell under different return levels indicate that drought risk in region 1 is higher than that in regions 2 and 3. The analysis of the occurrence day of MxDS shows that MxDS mostly occurred during winter of 1998 and spring of 1999 in most stations during the considered period. By comparing summer MxDS events, it can be found that mean MxDS values have slightly increased in regions 1 and 2 during the last five decades. The maximum mean MxDS values appeared in the 2000s for regions 1 and 2 and in the 1990s for region 3. The atmospheric circulation shows that the positive anomaly centre in the west of North China, negative anomaly centre in the east of North China and the strong western Pacific subtropical high led to the decrease of precipitation in North China during the summer of 1997. Copyright © 2013 John Wiley & Sons, Ltd.  相似文献   

Modeling deepwater seabed steady-state thermal fields around buried pipeline including trenching and backfill effects     

《Computers and Geotechnics》2014

Deepwater pipelines are designed to transport mixtures of oil and gas, and their associated impurities at wellhead temperatures that can be in excess of 149 °C (∼300 °F or 422 K) while the external temperature maybe in the range of 5 °C (∼41 °F or 278 K). Depending on the circumstances these pipelines may be buried for physical protection or for additional thermal insulation using robotic trenching equipment. This results in a complex cut and backfill geometry in the seafloor in addition to altering the thermal properties of the backfill. A two-dimensional boundary element model was developed specifically to address to investigate the local steady-state thermal field in the near field of the pipeline. The model allows one to account for the complex geometries in the near field associated with this burial technique, site-specific multi-layered soil conditions and the seawater adjacent to the seafloor. A parametric study was preformed to evaluate effects of the thermal power loss, burial depth, pipe diameter and soil thermal conductivity on the thermal field in the near field of a buried pipeline. The numerical examples illustrate the influence of the backfill thermal property on the temperature at the pipe wall, that the pipe diameter controls the required output thermal power needed to maintain the desired pipe wall temperature, and the importance of pipeline burial depth on seabed temperature distribution above the pipeline.  相似文献   

Critical Top Tension for Static Equilibrium Configuration of A Steel Catenary Riser     

Chainarong ATHISAKUL  Karun KLAYCHAM  Somchai CHUCHEEPSAKUL 《中国海洋工程》2014,(6):829-842

This paper aims to present the critical top tension for static equilibrium configurations of a steel catenary riser（SCR） by using the finite element method. The critical top tension is the minimum top tension that can maintain the equilibrium of the SCR. If the top tension is smaller than the critical value, the equilibrium of the SCR does not exist. If the top tension is larger than the critical value, there are two possible equilibrium configurations. These two configurations exhibit the nonlinear large displacement. The configuration with the smaller displacement is stable, while the one with larger displacement is unstable. The numerical results show that the increases in the riser＇s vertical distances, horizontal offsets, riser＇s weights, internal flow velocities, and current velocities increase the critical top tensions of the SCR. In addition, the parametric studies are also performed in order to investigate the limit states for the analysis and design of the SCR.  相似文献   

浅析如何在溶剂萃取机理研究中正确使用斜率法          下载免费PDF全文

高丹丹  李东东 《盐湖研究》2019,27(3):27-34

斜率法是萃取机理研究最为常用的方法之一。尽管其理论基础和使用方法非常简单,但该方法却常常被误用,导致其非但不能有效的确定萃取机理,反而产生了误导性结论。本文以t-BAMBP萃取碱金属离子(K~+、Rb~+、Cs~+)体系为例讨论了常见的错误用法以及造成这类情况的根源问题,之后对其他萃取体系中类似错误用法进行了简要评述,表明斜率法的错误使用主要源于对萃取反应方程式的错误假定及对工作方程推导过程中引入的近似处理理解不当。最后总结了在萃取机理研究中正确使用斜率法的几点注意事项。  相似文献